The peeling procedure of the protective film and the operation method of washing with water
Many protective film use terminals, such as injection molding factories, glass processing, and touch screen manufacturers do not know the steps to peel off the protective film, which often causes unnecessary troubles when using the protective film and affects production efficiency.
We have been producing protective films for 16 years. We not only have long-term and stable experience in the production and management of protective films, but also have accumulated a lot of experience in the terminal use of protective films.
With the improvement of living standards, TVs, computers and other products have become quite popular, so the corresponding protective film products are becoming more and more popular. The function of the protective film here is to prevent the liquid crystal display from being damaged, and it is also to facilitate the cleaning of the liquid crystal display.
Although it is known that a protective film can be pasted on the LCD screen to protect it, it is not known that the protective film here can be cleaned in different ways. One is to use the special dust removal sticker for the protective film to clean, which can not only clean the screen, but also not cause damage to the protective film and the screen.
When operating, first stick the dust removal sticker on the protective film, tear off the dust removal sticker again, and stick it to the corner of the protective film. And press the dust removal sticker firmly to make it stick to the protective film. Pull up the film in the opposite direction, and one corner of the protective film will be pulled up immediately. At this time, you can stick the second dust removal sticker on the adsorption layer of the protective film, corresponding to the position of the first dust removal sticker. Now you can Peel off the protective film.
After cleaning, re-paste the protective film. Since the adsorption layer of the protective film is less protected by the release film, you must be extra careful when re-pasting it to avoid damaging the protective film.
Of course, the protective film can also be washed with water, prepare a larger cup and fill it with pure water; then remove the protective film from the screen with a dust removal sticker, put the protective film in water and wash it back and forth. After washing the protective film, remove it from the water and place it in a cool place.
It is recommended to lean the protective film against the cup so that the adsorption layer of the protective film is downward, and it can be reattached after the water drops are completely dry. It should be kept in mind that the protective film must be dried naturally after washing, and the absorbent layer cannot be wiped with a soft cloth, otherwise it will stick to dust. If you accidentally stick to dust, you can wash it again with water.